Request AudioReQuest N.Series Informations techniques télécharger pdf (Page 13)

Phone (518) 899-1254 • Fax (518) 899-1251 • www.request.com

9 -

The final step is to determine how you will control the newly added ARQ devices and connect the signals

to/from the module.

Serial Control

1. Select an open COM port for each ARQ you have added to the system.

2. Copy the signals from Port A to the new COM port

3. Modify the signal names, changing ARQ_01 to ARQ_

, where

is the number of the

AudioReQuest you are adding.

4. Open the ARQConnect Basic v6_0_0 module into detail view and make sure the ARQ-

CONNECT{ARQ_

} signal is connected to the

[START-SERIAL-COMMUNICATIONS]

input.

Ethernet Control

**NOTE: There is one TCP/IP client in the system already and is configured for ARQ_01. Use that one

first before adding another to the system. Be sure to modify ARQ_01 to the ARQ number you

need if necessary.

1. Switch to Configure View and add a TCP/IP client to your list of Ethernet Units (Figure 10).

2. Edit the TCP/IP client, entering the IP Address of your AudioReQuest (Figure 11).

3. Switch back to Program View.

4. Copy the signals from the existing TCP/IP client to the newly added TCP/IP client.

5. Modify the signal names, changing ARQ_01 to ARQ_

, where

is the number of the

AudioReQuest you are adding.

6. Open the ARQConnect Basic v6_0_0 module into detail view and make sure the ARQ-

CONNECT{ARQ_

} signal is connected to the

[START-ETHERNET-COMMUNICATIONS]

input.

Figure 11

Figure 10

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Pas de commentaire

Request AudioReQuest N.Series Informations techniques Page 13